HomeOutdoor DecorDIY Mini Succulent Garden (in a Tree Stump)

DIY Mini Succulent Garden (in a Tree Stump)

How to repurpose a tree stump to create a mini succulent garden. 

This tree stump succulent garden was a sort of an out of the blue project. We are trying to find ways to spruce up our patio for the home we rent.

We are always in a quandary because we love being outdoors and having nice gardens and landscapes around us, but we don’t have much of a budget to be buying things for someone else’s home. 

tree stump succulent garden

I started having grand ideas about extending the patio and creating some sort of semi-temporary screened-in area.

As my realistic self got in touch with me, I pulled back some. What could I do with a very minimal budget and a limited supply of materials?

My eyes settled upon a tree stump right next to where I would have liked to extend the patio (and probably still will).

This tree stump succulent garden actually has a unique look to it, but the thing is almost completely rotted, surrounded by ivy and ant infested.

I knew my available supply of materials included soil, cement, a few plants, and some gardening tools.

So why not turn this tree stump into a mini succulent garden?

Tree Stump Mini Succulent Garden

My challenges were that I don’t know a ton about planting plants in the actual ground, just in planters.

The obvious was how to deal with insects and grub digging vermin. I thought I might be able to tackle one of the two by pouring a layer of cement on the bottom. 

The only way to keep the dirt and grub diggers out is to cage it off. I prefer not to do that, so I may have to live with that.

I’m living with that problem now anyway, I often come out to the patio to see one of my succulents uprooted from its planter- but I’m working on something for that too (hint of a future project).

Again, keep in mind, this was written during the Stay At Home orders so I very much was limiting my trips and wanted to stick with materials I had on-hand.

I have some of the plants planted there only temporarily and plan to both add and change out a few plants, once our nursery opens again. 

This is an easy project, but if your tree stump isn’t rotted, it will probably require a fair bit of elbow grease and some drilling and chopping to carve out the center.

Some of the links on this page have been provided as a convenience for finding materials. These links may also be affiliate links. As an Amazon Associate I earn from qualifying purchases, at no extra cost to you.

I only recommend products I’ve used and loved, unless otherwise stated. Click here to read my full disclosure policy.

DIY Difficulty Level | Easy

Materials For A Succulent Garden In A Tree Stump

Tutorial Steps For A DIY Tree Stump Succulent Garden

Step 1. Hollow Out The Tree Stump

tree stump hollowed in preparation for a mini succulent garden
Hollowed out tree stump

Like I mentioned in the intro, this part was a cinch for me since nearly the entire stump was rotted.

Assuming your stump is the same, put on some gardening gloves and use a trowel to dig out the rotted wood.

Then scoop out the dirt, powdered wood and bark from inside.

You may want to consider using a product like Diatomaceous Earth to keep the bugs at bay- but this may be overkill because the cement should keep most of them out.

**For another repurposed garden idea, check out my Cinder Block Planter wall.

Step 2. Create Drainage For the Succulent Garden

Cut a large straw into 3 or 4 pieces and place them at the low points in the bottom of the hollowed stump. This will allow you to have drainage in the cement.

Step 3. Prepare The Stump For The Cement

If I had landscape fabric on hand, I would have laid that down prior to pouring the cement. So I recommend doing that first, then cut holes to fit over the straws.

The reason for this is because when you spread the cement, it will pick up a decent amount of what’s leftover in the hollowed stump and make it slightly bothersome to spread.

Fabric will eliminate that problem. 

Since I didn’t have any landscape fabric, I ended up layering some sand in there instead to act as a barrier above the rotted wood and also to help level out the bottom.

Step 4. Mix And Cast The Cement

pour cement into tree stump

Mix the cement to the consistency of a thick milkshake. I poured some in the hole and then spread it around with my gloved hand.

As you spread, just scoop up more cement and build up the sides as you go. I ended up letting the first batch cure so that spreading would be easier. 

spreading cement in stump

Since my long-term plan was to put a fair amount of ground spreading succulents in the stump, I went ahead and covered the top edges of the stump with cement since I knew they would be obscured. 

Let this cure for an hour.

Step 5. Prepare The Garden Bed

cured cement with straw holding space for succulent soil drainage

Once the cement has cured, you can begin layering the garden materials for the mini succulent garden. Start by removing the drainage straws from the cement. 

pebbles added to stump to help with drainage

Next, add a layer of drainage pebbles. 

soil planted in hollowed tree stump

The next layer is your soil. I didn’t have succulent soil so I used regular organic soil and mixed in perlite, as well as a few more rocks.

shears cutting weeds for succulent garden

Step 6. Create The Tree Stump Mini Succulent Garden

Clean up the area around the stump and then go ahead and add your succulents. Add some smooth black river stones, or decorate anyway you’d like.

If you like this tutorial then you may like this one where I repurposed an old 1940’s smudge pot into a planter.

Don’t forget to Pin it for later!

How to make a Tree Stump Mini Succulent Garden

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.